How to program the KEY 900 (TXB-R) remote control

Programming manual KEY 900 (TXB-R) remote controls

Preliminary steps to program the Key 900 (TXB-R) remote control. After turning on the power receiver performs an internal test and causes the LR1 signal lamps to flash twice slowly and twice quickly, which means it is ready for further operation.

Loading Key 900 remote controls (TXB-R)

1. Press the "P" button on the receiver/control unit once - the LED will start blinking for about 10 seconds.
2. During this time, press the button on the remote control that you want to memorize for 2-3 seconds - the LED will light up continuously for 2 seconds.
3. The LED will start flashing again for approximately 6 seconds. During this time, we can load other remote controls or wait until it goes off. If the same code/button/channel is entered twice during programming, the LR1 light will flash quickly, which means that this code/button/channel is already in memory.

Deleting the programmed code of a single remote control

1. Press the "P" button and then press the "S" button. The LR1 indicator light will blink twice and flash rapidly for 10 seconds to indicate clear code mode has been activated.
2. Pressing the transmitter/remote button during this time deletes its code from memory. After the code has been successfully deleted from memory, the LR1 indicator light will come on for 2 seconds.

After deleting the code, the receiver immediately exits the code deleting mode. To remove another code, repeat the procedure described above.

ATTENTION! – When deleting the Key 900 (TXB-R) remote control code, the code of a given transmitter/remote control along with all channels of this transmitter/remote control (if they have been entered/remembered) will be deleted from the receiver/control panel memory.
For example, canceling/deleting channel "1" automatically means deleting channels "2", "3" and "4" from the memory.

Resetting the receiver/control unit (erasing all codes)

1. Turn off the power.
2. Press the P button and keep it pressed.
3. Turn on the power.
4. After at least 10 seconds, release the button.
5. Wait about 1 minute. until the LED stops flashing. Now you have deleted all remote controls from the receiver.

Output programming
The "S" button allows you to select the programmable output. The LR1 signal light is a visual confirmation of the selection made. After selecting the output, the programming button "P" allows you to define the output type:

• mono-stable (1 flash of the LR1 lamp)
• bistable (2 flashes of the LR1 lamp)
• according to the timer (3 flashes of the LR1 lamp)
• on-off (4 flashes of the LR1 lamp)

Pressing the "P" button allows you to change the number of flashes and, consequently, the way the device is programmed.

ATTENTION! – If no output has been selected using the "S" button, pressing the "P" button will automatically program the first output.