How to program the pilot Wiśniowski Lunar?

Wiśniowski Lunar remote controls are modern and reliable devices for controlling garage and entrance gates. Although their operation is very simple, they should be programmed correctly before the first use. That is why we have prepared this guide, which will lead you step by step through the whole process, explaining how to program the pilot Wiśniowski Lunar.

---

When is it worth programming the remote control?

There are several situations in which it is necessary to program the remote control again. First of all, this happens after buying a new device. What's more, the remote control should also be programmed after the control panel reset, drive replacement or setting the settings. Thanks to this, you will keep the full functionality of the gate and avoid unnecessary problems.

---

How to program a remote control Wiśniowski Lunar?

The following instruction applies to the most popular Wiśniowski drives, such as Metro, Moto or Drive. It is worth noting, however, that some models may differ slightly. Therefore, we recommend that you get acquainted with the user manual before starting.

Step 1: Open the gate drive housing

At the beginning, locate the gate drive - it is usually in the garage or at the fence. Then disconnect the power supply for a few seconds and connect it again. In some models, you activate learning mode in this way.

Step 2: Press the "Program" or "Learn" button

After opening the housing, you will find a small button marked as "program", "Learn" or a radio icon presented. Press it and hold it for about 1-2 seconds - the LED should start flashing, which means that the device is ready to program the remote control.

Step 3: Press the button on the remote control

Now, in a few seconds, press and hold the selected button on the Lunar remote control. If everything went well, the LED on the headquarters will stop flashing or starting to shine with continuous light. In this way, the pilot was assigned to the system.

Step 4: Finish programming

Finally, close the drive housing and check that the remote control works properly. If so, it means that the whole process was successful. Otherwise, it is worth repeating all the steps, making sure you follow the order.

---

What to do if the pilot does not work?

Despite the correct behavior, sometimes the pilot may not work. In this situation, it is worth considering several options:

Check the battery - Low signal quality often results from a poor battery. Therefore, its exchange can solve the problem.

Make sure the devices are compatible - Not all Lunar pilots work with older drive models. If you have doubts, check compliance in the instructions or contact a specialist.

Repeat programming - In some cases, it may be necessary to perform the procedure several times.

---

Summary

As you can see, programming the pilot Wiśniowski Lunar is not difficult - just a few simple steps. The most important thing is to keep calm and carefully perform further activities. Thanks to this, you will avoid frustration and ensure convenient access to the gate every day.

If you need a new pilot, accessories or additional help - check our offer on Ster-Tronic.pl. We are happy to advise!