BL-10 24VDC battery charging balancer

Description

Bl-10 24VDC battery charging balance, also commonly known as the voltage alignouser is a device for maintaining 12 V battery tensions at the same level connected together in a serial system.
Thanks to this, individual system batteries They are protected Before reloading, which can lead to excessive gassing as well as before uneven discharge, which can lead to sulfur, which in both cases may result in permanent damage to the batteries.
The principle of action is based on Independent measuring tensions of two batteries 12V Connected in Bank 24V, determining the middle point of such a series of batteries and energy transfer from a battery with higher battery voltage with lower voltage.

Thanks to the high current efficiency of the BL series balancers, they are suitable for use with small batteries (40AH) and also with large capacity (200AH).
If there is a need to build a 12V energy bank with a voltage higher than 24 V batteries, a series of batteries and balancers in the system should be connected in series:

• 36V - 3 batteries and 2 balancers
• 48V - 4 batteries and 3 balances

Technical data

• Power voltage: 15V ÷ 30V
• Balanced voltage range: 18V ÷ 30V
• Maximum balancing current: 10A
• Recommended battery capacity: 80Ah ÷ 240AH
• Overload protection: 11A
• Fuse: 15A
• Thermal security: 70 C
• Current consumption without load: 13mA
• Executive interference: below 50mv
• Input interference: below 50mv
• operating temperature range: -25 to 50 degrees C
• Alarm connectors: 2A
• Efficiency: 92%
• Cooling: Active
• output: 5x M4 screw connector
• Casing: aluminum
• Protection degree: IP21
• Dimensions (length x Sz. X height): 150x95x55 [mm]
• Weight: 500g

Electrical device - install and operate in accordance with the requirements contained in the product card and installation instructions.