Pilot GTI2 DEA 433 MHz - replacement

Description

Pilot GTI2 DEA 433 MHz - replacement with the function of changing the transmission code

Pilot GTI2 DEA 433 MHz - replacement For automatic gates it is a modern device that allows you to easily change the transmission code and quickly programming with the receiver. The remote control supports three coding modes: HCS Rolling Code (red LED), DIP Switch HT12 (Green LED) and Dart dea Advanced Rolling Transmission (flashing in red/green LED).

How to change the code transmission type in the GTI2 dea 433 MHz remote control:

1. Hold the buttons at the same time T1 and T2 For about 10 seconds until the LEDs light up.

2. Check LED flashing:

• 1 time a second = HCS Rolling Code
• 2 times per second = DIP Switch HT12
• 3 times per second = dart

1. Press the button T1and then use T2to change the coding mode.

2. When you choose the right mode, hold down T2 For 5 seconds, until the diodes go out - the pilot will remember a new type of code.

Programming of the GTI2 DEA 433 MHz remote control to the receiver:

1. Open the gate controller housing and find the programming button P1.

2. Press the button P1 - The LED on the receiver's motherboard should light up.

3. In 10 seconds, press and hold the selected remote control button GTI2 DEA For 5-10 seconds, until the diode on the receiver begins to flash. This means that programming has ended successfully.

4. To program the next buttons, repeat the same process.

5. After programming, restart the control panel - turn off and turn on the power supply again.