Solar battery charging controller SCC-100A-PWM-LCD-S2
132.48 zloty
- EUR: 31.11€
Photovoltaic panels are a clean and ecological source of electricity. Obtaining this energy, however, poses a number of challenges for device designers. The amount of energy produced by a panel is strongly dependent on the angle of incidence and the intensity of light falling on the surface of the cells. This in turn leads to unstable power supply parameters at the output, because even shading a small part of the panel may result in a drastic reduction in efficiency
- Description
- Additional information
- Mark
- Opinions (0)
Description
Composition:
Photovoltaic panels are a clean and ecological source of electricity. Obtaining this energy, however, poses a number of challenges for device designers. The amount of energy produced by a panel is strongly dependent on the angle of incidence and the intensity of light falling on the surface of the cells. This in turn leads to unstable power supply parameters at the output, because even shading a small part of the panel may result in a drastic reduction in efficiency
The optimal solution to the above-mentioned problems is to use a set consisting of a photovoltaic panel, a battery and a charging regulator. Such a set allows to ensure constant power supply parameters for the receivers, and also to store excess energy produced for later use.
The SCC-100A-PWM-LCD-S2 solar controller allows you to connect panels connected to each other both in series and in parallel - remembering not to exceed the permissible current and voltage values at the device input.
Attention! Solar controllers are designed to work with photovoltaic panels. They should not be used with other power sources
Dosage:
Regulation type: | PWM |
Rated voltage: | 12/24V |
Rated current: | 100 A |
Permissible voltage range: | max. 23 V for a 12 V battery – Range of the highest operating voltage of a set of panels connected to one regulator input, max. 46 V for a 24 V battery – The highest operating voltage range of a set of panels connected to one regulator input |
Battery charging current: | max. 100 A |
Load current: | max. 30A |
Output voltage: |
|
Selected features: |
|
Libra: | 0.28 kg |
Dimensions: | 190 x 94 x 37 mm |
Guarantee: | 2 years |
Additional information
Libra | 0.33kg |
---|---|
Libra | |
Length | 195 |
Width | 100 |
Height | 50 |
EAN | |
Producer |
Mark
STER-TRONIC
Be the first to review "Solar battery charging controller SCC-100A-PWM-LCD-S2" Cancel reply
also check
-
Photovoltaics accessories , Photovoltaics , Emergency power supply
End clamp PV-KK/40-50/B FOR PHOTOVOLTAIC PANELS 40 mm
0 out of 5- EUR: 0.62€
24 in stock
-
Photovoltaics accessories , Photovoltaics , Emergency power supply
End clamp PV-KK/35-50/B FOR PHOTOVOLTAIC PANELS 35 mm
0 out of 5- EUR: 0.70€
7 in stock
-
Photovoltaics accessories , Photovoltaics , Emergency power supply
Pole holder USP-SUN-340 FOR PHOTOVOLTAIC PANELS
0 out of 5- EUR: 167.17€
6 in stock
-
Photovoltaics accessories , Photovoltaics , Emergency power supply
Hex head screw SS-M8X50/KL-8.8
0 out of 5- EUR: 0.21€
80 in stock
Opinions
There are no opinions about the product yet.